A beaker is filled with a liquid up to a height h. If A and B are two points, one on the free surface and one at the base as shown, such that the minimum distance between the two is l, what will be the pressure at point B?

← Prev Question Next Question →

Please log in or register to answer this question.

Related questions

+1 vote

0 answers

A beaker is filled with a liquid of density ρ1 up to a certain height. A is a point, h m downwards from the free surface such that the pressure at A is P. If the liquid is replaced by equal volume of another liquid of density ρ2, at what distance from the free surface will the pressure be P now?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A beaker of height h is filled with a liquid of density ρ up to a certain limit. The beaker is rotated by an angle θ such that further increase in the angle will result in over flow of the liquid. If the liquid surface is exposed to the atmosphere, what will be the gauge pressure at point B?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

A beaker is filled with a liquid of density ρ1 up to a certain height. A is a point, h m downwards from the free surface of the liquid as shown. The liquid is replaced by equal volume of another liquid of density ρ2. If ρ1 > ρ2, how will the pressure at point A change?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

A beaker is filled with a liquid of specific gravity S = 1:2 as shown. What will be the pressure difference (in kN/m^2) between the two points A and B, 30 cm below and 10 cm to the right of point A?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

A beaker, partially filled with a liquid is rotated by an angle 30^o as shown. If the pressure at point B becomes 12 bar, what will be the height (in cm) of the beaker?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A beaker half-filled with water is exposed to the atmosphere. If the pressure at points A, B and C as shown are Pa, Pb and Pc respectively, which one of the following will be the relation connecting the three?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

A beaker is filled with a liquid of density ρ up to a height h. If half the liquid is replaced by equal volume of another liquid of twice the density, what will be the change in the base pressure?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

Three beakers 1, 2 and 3 of different shapes are kept on a horizontal table and filled with water up to a height h. If the pressure at the base of the beakers are P1, P2 and P3 respectively, which one of the following will be the relation connecting the three?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

A beaker of height 30 cm is filled with water (Sw = 1) up to a height of 10 cm. Now oil (So = 0:9) is poured into the beaker till it is completely filled. At what distance (in cm) from the base will the pressure be one-third the pressure at the base of the beaker?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

0 answers

A beaker is filled with a liquid of density ρ1 up to a certain height. The pressure at the base of the beaker id Pb. If the liquid is replaced by an equal volume of another liquid of density ρ2, what will be the pressure at the base of the beaker now?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

An arm of a teapot is completely filled with tea (density=ρ) If the arm has a length of l and is inclined at 30^o to the horizontal, what will be the pressure difference between the two points, C at the mouth and D at the base of the arm?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A beaker of height h is completely filled with water. Now two-third of the liquid is replaced by another liquid. If the pressure at the base of the beaker doubled, what is the specific gravity of the liquid poured?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A beaker of height 15 cm is completely filled with water. Now two-third of the liquid is taken out and an equal amount of two other immiscible liquids of specific gravities 0.8 and 1.2 are poured into the tank. What will be the pressure (in kPa) at a point situated at a height, half the height of the beaker?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

The arm of a teapot is 10 cm long and inclined at an angle of 60^o to the vertical. The center of the arm base is 2 cm above the base of the beaker. Water is poured into the beaker such that half the arm is filled with it. What will be the pressure at the base of the beaker if the atmospheric pressure is 101.3 kPa?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+2 votes

1 answer

A beaker of height 10 cm is half-filled with water (Sw = 1) and half-filled with oil (So = 1). At what distance (in cm) from the base will the pressure be half the pressure at the base of the beaker?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A cuboidal container (each side of 30 cm0) is completely filled with water. A is a point, 25 cm above the base such that the pressure at point A is P. At what height (in cm) from the base will the pressure be 2P?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A tank of height 3 m is completely filled with water. Now two-third of the liquid is taken out and an equal amount of two other immiscible liquids of specific gravities 0.8 and 1.2 are poured into the tank. By what percent will the pressure at the base of the tank change?

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A large tank of height h is half-filled with a liquid of density ρ and other half-filled with a liquid of density 4ρ. A similar tank is half-filled with a liquid of density 2ρ and other-half filled with another liquid of density 3ρ as shown. What will be the ratio of the instantaneous velocities of discharge through a small opening at the base of the tanks? (assume that the diameter of the opening is negligible compared to the height of the liquid column in either of the tanks)

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A large tank of height h is filled with a liquid of density ρ. A similar tank is half-filled with this liquid and other-halffilled with another liquid of density 2ρ as shown. What will be the ratio of the instantaneous velocities of discharge through a small opening at the base of the tanks? (assume that the diameter of the opening is negligible compared to the height of the liquid column in either of the tanks)

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

0 votes

0 answers

A large tank is filled with three liquids of densities ρ, 2ρ and 3ρ up to heights of ^h ⁄ 6, ^h ⁄ 3 and ^h ⁄ 2 respectively. What will be the ratio of the instantaneous velocity of discharge through a small opening at the base of the tank in this case to that if the container is filled with the liquid of density ρ only? (assume that the diameter of the opening is negligible compared to the height of the liquid column)

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

A closed tank (each side of 5 m) is partially filled with fluid as shown. If the pressure of the air above the fluid is 2 bar, find the pressure at the bottom of the tank. Assume the density ρ of the fluid to vary according to the given relation:

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

The pressure gauges 1, 2 and 3 are installed on the system as shown. If the readings of the gauges be P1 = 1 bar, P2 = 2bar and P3 = 3 bar, what will be the value of P? (Take Patm = 1.01 bar)

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

0 votes

0 answers

A large tank is filled with three liquids of densities ρ, 2ρ and 3ρ up to a height of ^h ⁄ 3 each. What will be the expression for the instantaneous velocity of discharge through a small opening at the base of the tank? (assume that the diameter of the opening is negligible compared to the height of the liquid column)

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

If a gas X be confined inside a bulb as shown, by what percent will the pressure of the gas be higher or lower than the atmospheric pressure? (Take the atmospheric pressure equal to 101.3 kPa)

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

+1 vote

1 answer

If the pressure at a point is 1m of water, what will be it’s value in terms of m of oil? (Take, the specific gravity of oil to be 0.8)

asked Jan 30, 2022 in Fluid Mechanics by Charlotte (118k points)

...