The fraction of volume occupied by the gas-liquid mixture in the equipment/vessel to the volume occupied by the gas is

Question

The fraction of volume occupied by the gas-liquid mixture in the equipment/vessel to the volume occupied by the gas is

1 Answer

Related questions

+1 vote

1 answer

Guess the diameter of the bubble for an air-water system in a sparged vessel with gas holdup of 0.1 and liquid flow rate of 0.15 meters per second.

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

During gas dispersion, if a chemical reaction between gas and liquid phase is needed, then the preferred equipment is

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

In a Sparged vessel of area 50 cm, the flow rate of the gas is 2 cubic meters per second then the value of superficial gas velocity in meters per second is

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

In sparged vessel of area 50 cm and a gas holdup of 3 cubic meters per cubic meters, the flow rate of the gas is 5 cubic meters per second. The value of true gas velocity in meters per second is

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

For the multistage counter current gas dispersed operation, which of the following equipment is better?

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

Guess the interfacial area of a bubble with a gas volume of 2.5 x10^-3 cubic meters and diameter of 0.125 cm.

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

If the relative velocity of the gas and liquid inside the bubble column of cross sectional area 0.2 meters with gas holdup of 0.736 is 3.6 meters square per second. The expected slip velocity is

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

Find the process where an agitated vessel is required.

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

In a Bubble column, if the velocity of the gas is low, then the bubble diameter is equals to______

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

The higher difference in pressure inside the tray tower cause

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

For a better stage efficiency, must have large interfacial surface and low mass transfer co-efficient.

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find molar fraction of nitrogen

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find mass fraction of oxygen

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

The equilibrium concentrations in the gas and the liquid phases, in mole fraction, give rise to a curve known as

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

Consider an ideal vapour-liquid binary mixture, find the total pressure if the vapour pressure of A is 260 mmHg and the vapour pressure of B is 520 mmHg and the composition of A in mole fraction is 0.55.

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

Find the x & y co-ordinate in the figure below at steady state. Here, the gas phase and liquid phase mole fraction representation is given below

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

If the whole liquid and gas flow rates are same, we can use the mole fraction for getting a straight operating line

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

Gas absorption is the process of transferring solute component from liquid solvent to gas mixture.

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

Is the extraction is possible if a gas solvent is used for extracting solute from liquid mixture.

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

A solution contains 0.3 moles of solute A, 0.2 moles of B and 0.5 moles of C. What will be the mole fraction of A in the mixture?

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

A binary liquid mixture is separated by distillation process. The more volatile A vaporizes while less volatile B gets transported in opposite direction. Latent heat of vaporization of A and B is 0.5unit and 1unit respectively. What will be the relation between molar flux of A and B

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find molar concentration of oxygen

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find overall mass density

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find the average molecular weight of the mixture

asked Sep 20, 2022 in Mass Transfer by Julian (39.8k points)

+1 vote

1 answer

Liquid-liquid mixture is separated with solvent extraction by adding _______ solvent.

asked Sep 21, 2022 in Mass Transfer by Julian (39.8k points)

Chris · Answer 1 · 2022-10-12T21:41:30+0000

The correct answer is (b) Gas holdup

Easiest explanation: The gas holdup gives the fraction of gas in the gas-liquid mixture.

The fraction of volume occupied by the gas-liquid mixture in the equipment/vessel to the volume occupied by the gas is

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions

Categories