During gas dispersion, if a chemical reaction between gas and liquid phase is needed, then the preferred equipment is

Question

During gas dispersion, if a chemical reaction between gas and liquid phase is needed, then the preferred equipment is

← Prev Question Next Question →

1 Answer

Related questions

+1 vote

1 answer

The fraction of volume occupied by the gas-liquid mixture in the equipment/vessel to the volume occupied by the gas is

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

If the relative velocity of the gas and liquid inside the bubble column of cross sectional area 0.2 meters with gas holdup of 0.736 is 3.6 meters square per second. The expected slip velocity is

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

In a Bubble column, if the velocity of the gas is low, then the bubble diameter is equals to______

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Guess the diameter of the bubble for an air-water system in a sparged vessel with gas holdup of 0.1 and liquid flow rate of 0.15 meters per second.

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

For the multistage counter current gas dispersed operation, which of the following equipment is better?

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

In a Sparged vessel of area 50 cm, the flow rate of the gas is 2 cubic meters per second then the value of superficial gas velocity in meters per second is

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

In sparged vessel of area 50 cm and a gas holdup of 3 cubic meters per cubic meters, the flow rate of the gas is 5 cubic meters per second. The value of true gas velocity in meters per second is

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Guess the interfacial area of a bubble with a gas volume of 2.5 x10^-3 cubic meters and diameter of 0.125 cm.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

For a better stage efficiency, must have large interfacial surface and low mass transfer co-efficient.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the process where an agitated vessel is required.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The higher difference in pressure inside the tray tower cause

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the gas phase mass transfer co-efficient for a unbound moisture to remove if the flux is 5 kg/sq.m sec and the difference in humidity of the liquid and the main stream is 0.5 units.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

If the gas phase composition of a component A is 0.65 and its relative volatility is 2. Find the liquid phase composition.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the x & y co-ordinate in the figure below at steady state. Here, the gas phase and liquid phase mole fraction representation is given below

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The extractor preferred for getting immediate dispersion after piping is ___________________

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

If the distillate has a composition of azeotrope and the residue has rich phase of one component. Then the azeotropic mixture is a

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the rate of non-diffusing solute, if the mole fraction of the gas phase is 0.65 and the diffusing rate is 70 moles/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

If the whole liquid and gas flow rates are same, we can use the mole fraction for getting a straight operating line

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the flow rate of liquid entering into the enriching section if the internal reflux ratio is 1.5 times min. Given minimum reflux ratio is 0.95 and the gas flow rate is 35 mol/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Is the extraction is possible if a gas solvent is used for extracting solute from liquid mixture.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

If the feed mixture has the same vapour and liquid compositions at equilibrium then the distillation is normal.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The equilibrium concentrations in the gas and the liquid phases, in mole fraction, give rise to a curve known as

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

After leaving the condenser if the liquid is at bubble point then which of the following is correct?

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

If the equilibrium vapour pressure is lower than pure liquid pressure then the moisture content is ___________

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The gas A diffuses through non-diffusing B from point 1 to point 2. The total pressure is 2atm and yA1=0.1 and yA2=0.Then the ratio (dPA/dz)1/(dPA/dz)2 is

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

Chris · Answer 1 · 2022-10-11T20:14:26+0000

Correct answer is (a) Agitated vessel

The explanation: For a reaction to occur we need agitation for a perfect mixing between two phases.

During gas dispersion, if a chemical reaction between gas and liquid phase is needed, then the preferred equipment is

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions

Categories