Given the total pressure is 2 atm. Also the partial pressure of the two components in an ideal solution is 1 atm and 0.5 atm. It shows __________ deviation.

Question

Given the total pressure is 2 atm. Also the partial pressure of the two components in an ideal solution is 1 atm and 0.5 atm. It shows __________ deviation.

← Prev Question Next Question →

1 Answer

Related questions

+1 vote

1 answer

If the vapour pressure of the two components in a binary mixture is same, then it is a________

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Negative deviation is due to a total pressure less than the pressure obtained from Hendry’s law.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

When the two liquid mixtures are completely insoluble then the total pressure of the mixture is

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the vapour pressure of component A in an ideal mixture, if its liquid composition and the partial pressure is 0.65 and 260 mmHg.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Oxygen diffuses through a stagnant layer of air, 1mm thick, ambient temperature 28°C and 1atm total pressure. The partial pressure of oxygen on two sides of layer is P1=0.9atm and P2=0.1atm respectively. Calculate the value of Molar flux (in mol/m^2.s) with respect to an observer moving with molar average velocity. Calculate this value at the end of the path where P2=0.1atm. Use R=8.205*10^-5m^3atmK^-1mol^-1.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Consider an ideal vapour-liquid binary mixture, find the total pressure if the vapour pressure of A is 260 mmHg and the vapour pressure of B is 520 mmHg and the composition of A in mole fraction is 0.55.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the partial pressure of A if the total pressure is 2 atm; Concentration of A is 2 mol/cu.m and total concentration is 5 mol/cu.m.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find molar concentration of oxygen

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find overall mass density

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find molar fraction of nitrogen

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find the average molecular weight of the mixture

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find mass fraction of oxygen

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

In order to prepare Lithium nitride, air is passed gently over a reactor. Suppose that Nitrogen diffuse to a length 5cm before getting reacted with Lithium. Nitrogen reacts with lithium quickly so that partial pressure of Nitrogen at that point is 0. Reactor is a cylinder of length 10cm and diameter 2cm. Assume air to be a mixture of Nitrogen and Oxygen only. The temperature is 298K and total pressure 1atm. Diffusivity of N2 in O2 is 2*10^-5m^2/s. Calculate the Molar flux (mol/m^2.s) of N2 at a distance of 2.5cm from the top with respect to an observer moving with twice the mass average velocity a direction towards the liquid surface. (R=8.205*10^-5m^3atmK^-1mol^-1). Assume z=0 at the top of the reactor.

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

In an accident a container containing ethanol(s.g 0.789) falls down in a room of dimension 1*1*2(all in m). Ethanol forms a layer of 2mm. Ethanol vaporizes and diffuses through a stagnant film of air of thickness 2.5mm. What will be the time required for the water layer to disappear completely. The diffusivity of ethanol in air is 2.567*10^-5 m^2/s. the total pressure is 1.013 bar and the pressure of ethanol in bulk air is 0.02244 bar and at the ethanol-air interface is 0.02718bar. The temperature is 25.2°C.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Alternative word of Azeotrope is a Differential-boiling point.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Ordinary distillation cannot separate Azeotrope.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Minimum boiling azeotrope has_________

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Express the point A

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Azeotropic composition can be eliminated by

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the flow rate of liquid entering into the enriching section if the internal reflux ratio is 1.5 times min. Given minimum reflux ratio is 0.95 and the gas flow rate is 35 mol/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Assume an ideal solution with pure component A, has a vapour pressure of 300 mmHg and the total pressure of 1atm. The concentration in terms of mole ratio is

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

In an experiment,the barometric pressure of gas is 1.043 atm, Some H2 was collected over water at 27.0°C. What is the partial pressure of the dry H2 in the container?

asked Feb 2, 2022 in Food Processing Unit Operations by Ava (110k points)

+1 vote

1 answer

For an air(A)-water vapour(B) mixture, the partial pressure of the air is 5 pa and the total pressure of the system is 15 pa. The absolute humidity in mass of air/mass of water vapour is

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the rate of distillate, if the composition of the more volatile component in the feed is 50% and the residue is 10% and the equilibrium relation is given by y*= 1.975x. Also the rate of residue is 60 mol/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Estimate the feed rate, if the composition of the more volatile component in the feed is 50% and the residue is 10% and the equilibrium relation is given by y*= 1.975x. Also, the rate of residue is 60 mol/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

Chris · Answer 1 · 2022-10-13T05:21:06+0000

Correct choice is (a) Positive

To explain: If the total pressure is greater than sum of partial pressure then it shows positive deviation.

Given the total pressure is 2 atm. Also the partial pressure of the two components in an ideal solution is 1 atm and 0.5 atm. It shows __________ deviation.

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions

Categories