The gas A diffuses through non-diffusing B from point 1 to point 2. The total pressure is 2atm and yA1=0.1 and yA2=0.Then the ratio (dPA/dz)1/(dPA/dz)2 is

Question

The gas A diffuses through non-diffusing B from point 1 to point 2. The total pressure is 2atm and yA1=0.1 and yA2=0.Then the ratio (dPA/dz)1/(dPA/dz)2 is

1 Answer

Related questions

+1 vote

1 answer

A sheet of Fe 1.0 mm thick is exposed to an oxidizing gas on one side and a deoxidizing gas on the other at 725°C. After reaching steady state, the Fe membrane is exposed to room temperature, and the C concentrations at each side of the membrane are 0.012 and 0.075 wt%. Calculate the diffusion coefficient (m^2/sec) if the diffusion flux is 1.4×10^-8kg/m^2-sec.

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

In industries titanium is hardened through diffusion of carbon. The concentration of carbon at 1mm into the surface of the titanium slab is 0.25kg/m^3 and at 3mm the concentration is 0.68kg/m^3. The rate at which the carbon is entering into its surface is 1.27*10-9kg/m^2.s. calculate the value of diffusion coefficient of carbon.

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

In the expression for molar flux NA=(NA+NB)CA/C – DABdCA/dz, the terms representing bulk flow and molecular diffusion are, respectively

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

Consider loss of ethanol vapor by diffusion from a half-filled open test tube. At what point in the diffusion path will the contribution of the bulk flow term to the molar flux be maximum?

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find molar concentration of oxygen

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find overall mass density

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find molar fraction of nitrogen

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find the average molecular weight of the mixture

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

A binary mixture of oxygen and nitrogen with partial pressures in the ratio 0.21 and 0.79 is contained in a vessel at 300 K. If the total pressure of the mixture is 1 * 10 ^5 N/m^2, find mass fraction of oxygen

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

A reaction 3A+2B+C=1.5D+E occurs in a reactor at steady state. What will be the value of the flux ratio NA/ND

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

Oxygen diffuses through a stagnant layer of air, 1mm thick, ambient temperature 28°C and 1atm total pressure. The partial pressure of oxygen on two sides of layer is P1=0.9atm and P2=0.1atm respectively. Calculate the value of Molar flux (in mol/m^2.s) with respect to an observer moving with molar average velocity. Calculate this value at the end of the path where P2=0.1atm. Use R=8.205*10^-5m^3atmK^-1mol^-1.

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

In an accident a container containing ethanol(s.g 0.789) falls down in a room of dimension 1*1*2(all in m). Ethanol forms a layer of 2mm. Ethanol vaporizes and diffuses through a stagnant film of air of thickness 2.5mm. What will be the time required for the water layer to disappear completely. The diffusivity of ethanol in air is 2.567*10^-5 m^2/s. the total pressure is 1.013 bar and the pressure of ethanol in bulk air is 0.02244 bar and at the ethanol-air interface is 0.02718bar. The temperature is 25.2°C.

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

If the value of N flux of A to the total N flux is 1 then it is a steady state diffusion of non-diffusing B.

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

At which condition molar flux with respect to a stationary observer and with respect to an observer moving with molar average velocity?

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

In sulphuric acid plants dry air is used for burning of sulphur. Air is dried in contact with concentrated Sulphuric acid. Moisture diffuses through a layer of air, reaches the surface and gets absorbed in it. Here air is said to be non-diffusing were as moisture is diffusing. Which of the following statements are correct?

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

In order to prepare Lithium nitride, air is passed gently over a reactor. Suppose that Nitrogen diffuse to a length 5cm before getting reacted with Lithium. Nitrogen reacts with lithium quickly so that partial pressure of Nitrogen at that point is 0. Reactor is a cylinder of length 10cm and diameter 2cm. Assume air to be a mixture of Nitrogen and Oxygen only. The temperature is 298K and total pressure 1atm. Diffusivity of N2 in O2 is 2*10^-5m^2/s. Calculate the Molar flux (mol/m^2.s) of N2 at a distance of 2.5cm from the top with respect to an observer moving with twice the mass average velocity a direction towards the liquid surface. (R=8.205*10^-5m^3atmK^-1mol^-1). Assume z=0 at the top of the reactor.

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

Which of the following statements are correct? (a)Water vapor diffuses through non-diffusing hydrogen and oxygen

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

Which among the following is the statement of the ‘Fick’s Law’?

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

For what kind of mixtures DAB=DBA holds?

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

A solution contains 0.3 moles of solute A, 0.2 moles of B and 0.5 moles of C. What will be the mole fraction of A in the mixture?

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

Consider a saturated gas(A.-vapour(B. mixture , if the absolute molal humidity is 0.265 and the total pressure= 760 mmHg. Find the vapour pressure of B.

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

For a Steady state diffusion of A through Non- diffusing B. N flux of B= ______

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

Find the rate of non-diffusing solute, if the mole fraction of the gas phase is 0.65 and the diffusing rate is 70 moles/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

For the molecular diffusion of liquids, if the diffusing molecules having criteria of steady state diffusion of B over non diffusing A then the N flux of A is

asked Sep 20, 2022 in Mass Transfer by Julian (38.2k points)

+1 vote

1 answer

Given for an absorber, the minimum non diffusing liquid flow rate is 20 moles/hr and the non diffusing gas flow rate is 30 moles/hr. As the actual liquid flow rate is 2.5 times the minimum. Find the slope of the operating line.

asked Sep 21, 2022 in Mass Transfer by Julian (38.2k points)

The gas A diffuses through non-diffusing B from point 1 to point 2. The total pressure is 2atm and yA1=0.1 and yA2=0.Then the ratio (dPA/dz)1/(dPA/dz)2 is

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions

Categories