The fictitious stream is the difference in the flow rates of the nth tray.

Question

The fictitious stream is the difference in the flow rates of the nth tray.

1 Answer

Related questions

+1 vote

1 answer

Find the flow rate of liquid entering into the enriching section if the internal reflux ratio is 1.5 times min. Given minimum reflux ratio is 0.95 and the gas flow rate is 35 mol/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The Ponchon Savorit method is applicable for determining negligible heat loss.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the heat removed by the condenser if the net heat out of the condenser is 25000 J and the total moles are 25.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

External reflux ratio is used for Ponchon Savorit method.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the internal reflux ratio by analysing the below fractionator.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Ponchon Savorit method do not include enthalpy concentration diagram.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

From the enthalpy-concentration diagram find the location of heat removed by the condenser.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the distillate rate by analysing the fractionator given below.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Estimate the heat removed by the condenser.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Non-equimolal flow rates are maintained in the fractionator obeying McCabe-Thiele method.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the ratio of distillate to residual flow rates, if a binary mixture containing 65% of more volatile component while the distillate and the residue compositions are 90% and 30%.

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The section above the feed tray in a fractionator is known as ______________

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The section below the feed tray in a fractionator is known as ______________

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the distillate and the residue rates in mole/hr, if the feed rate is 100 mol/hr; The compositions of feed, distillate and residue in terms of mole fraction are 0.65, 0.9 and 0.2.

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Which of the following reboiler is considering as an additional tray?

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

The higher difference in pressure inside the tray tower cause

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Binary mixture of 100 kmol/hr enters into a flash drum has equimolar composition. The distillate obtained is 60 kmol/hr and the enthalpy of distillate, residue and feed are 500 KJ/kmol, 200 KJ/kmol and 400 KJ/kmol. Find the bottom flow rate in kmol/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the gas phase mass transfer co-efficient for a unbound moisture to remove if the flux is 5 kg/sq.m sec and the difference in humidity of the liquid and the main stream is 0.5 units.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Consider a saturated liquid-vapour mixture, if the liquid flow rate inside the enriching and the stripping section of a fractionator is 50 and 40 mol/hr. Also the feed rate is 10 mol/hr. Find the feed condition.

asked Sep 20, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

If the whole liquid and gas flow rates are same, we can use the mole fraction for getting a straight operating line

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Will the Height equivalent theoretical plates changes with flow rates?

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Pre-cooling is required before passing the vapour to the condenser in a still.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Condenser or reboiler is consider as a trays or stage in a fractionator.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

In an operation the slope of the q-line is found to be 0; then the enthalpy of feed equals enthalpy of _____________

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

+1 vote

1 answer

Find the rate of distillate, if the composition of the more volatile component in the feed is 50% and the residue is 10% and the equilibrium relation is given by y*= 1.975x. Also the rate of residue is 60 mol/hr.

asked Sep 21, 2022 in Mass Transfer by Julian (37.1k points)

Chris · Answer 1 · 2022-10-12T09:10:53+0000

The correct answer is (a) True

To explain I would say: Fictitious stream = Gn+1 – Ln (Represented by delta).

The fictitious stream is the difference in the flow rates of the nth tray.

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions

Categories